Furnace & heating
AC repair
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateRheem AC Installation in Tampa: What to Know First
Rheem AC installation in Tampa typically runs between $3,500 and $7,500 depending on the model line, system size, and your home’s ductwork. We’re an independent Rheem service provider, which means we install and service Rheem equipment without being tied to the manufacturer. Most full Rheem installs happen within five to seven business days of your approved quote. If you’re in Tampa and your Rheem system is dead or dying, call (850) 608-1463 for a written estimate before anything else happens.
This page is for Tampa homeowners who already own a Rheem and want a straight answer on whether to repair or replace, what a new Rheem will actually cost here, and how the install process works without the usual runaround. Andre Fuller and our Tampa crew put every job in writing before a single tool comes off the truck.
How Rheem Products Fail – and How We Fix Them
- Classic Series condenser coil leaks. The Rheem Classic line (RA13/RA14) is everywhere in Tampa, and we see evaporator coil pinhole leaks on units that are seven to ten years old. The salt air near Channelside and Bayshore accelerates corrosion on the aluminum fins. The fix is either a coil replacement, which runs $1,200 to $2,000 on average, or a full AC installation if the compressor is also showing wear. We will tell you which one makes sense before any work is approved.
- Prestige Series inverter board failures. The Rheem Prestige line (RA20) uses variable-speed inverter technology, and the control boards can fail after power surges. Tampa’s afternoon lightning storms are a real culprit. A new OEM board is pricey but the right call on a unit under warranty. On an out-of-warranty Prestige, we sometimes recommend a quality aftermarket board or a full system replacement, depending on age and overall condition.
- ECM blower motor burnout on Rheem air handlers. We see this on Rheem RH1T and RH2T air handlers paired with heat pumps. Florida humidity means the blower runs constantly, and ECM motors wear faster than the old PSC style. A motor replacement runs $600 to $1,100. If your Rheem air handler is over twelve years old and the motor is shot, that’s usually the moment to price both a motor repair and a new Rheem AC installation side by side.
- Compressor contactor pitting on RA13 units. The contactor is the electrical switch that tells your compressor to start. In Tampa’s heat, the contacts arc and pit over time. The unit will click but not start, or start intermittently. This is a $150 to $300 repair and one of the most common Rheem fixes we make. But if the contactor is repeatedly failing, it’s often a sign of low refrigerant or a compressor pulling too many amps, which means the conversation shifts to replacement.
- Rheem capacitor failures in older R-22 units. Before the R-410A transition in 2010, Rheem units ran on R-22 refrigerant. Those systems are now at end of life. When the start capacitor goes on a 15-year-old R-22 Rheem, recharging with R-22 is no longer economical. Freon is phased out and expensive. The honest answer is usually a new Rheem central air installation rather than throwing money at a system that’s already on borrowed time.
Styles & brands we work with







Our Rheem AC Installation Process
- 1
Call or book online. You get a live arrival time and the technician’s name and photo before they show up. No four-hour windows, no phone tag.
- 2
Site inspection and load calculation. We measure the home, check ductwork, and run a Manual J calculation. A properly sized Rheem matters more than the brand name on the box – undersized units fail early in Tampa heat.
- 3
Written quote before any work. You get a fixed price with the exact model number, equipment line, labor, and warranty terms. Get the price in writing first – then we get to work.
- 4
Install day. We remove the old Rheem, inspect the line set and pad, then install the new system. That includes checking the duct connections and airflow, not just bolting in a box.
- 5
System test and refrigerant charge. We run the unit, check subcooling and superheat, verify airflow, and make sure the system is pulling the rated amps. Every Rheem install gets a full commissioning.
- 6
Cleanup and the 365-Day Done Right Promise. We leave the job site clean, walk you through the new thermostat, and hand you a written guarantee that covers the entire install for a full year.
What Rheem AC Installation Costs in Tampa
Rheem AC installation in Tampa runs $3,500 to $7,500 installed. Here’s how that breaks down:
- Rheem Classic Series (RA13/RA14), 14-16 SEER2: $3,500 to $4,800 installed.
- Rheem Endeavor Line, 15-17 SEER2: $4,500 to $6,000 installed.
- Rheem Prestige Series (RA20), up to 20 SEER2: $6,000 to $7,500 installed.
What moves the price: system tonnage, whether you need new ductwork or a new electrical disconnect, whether the existing line set can be reused, and whether you choose a heat pump or straight-cool unit. Tampa homes with older panels sometimes need a small electrical upgrade. We give you the full price in writing before we start. Call (850) 608-1463 for a free estimate.
See the difference
Before
After
Before
After
Before
AfterWhy Tampa Homeowners Call Halden Heating and Air Tampa for Rheem Work
Andre Fuller spent two-plus decades doing HVAC work, starting with classroom training at Los Angeles Trade-Technical College and building from there. He built Halden Heating and Air around one idea: put the price and the guarantee in writing before anyone touches a unit. That’s what we do on every Rheem job in Tampa.
Every Rheem AC installation includes a written price before work begins, a written guarantee on the install, and the 365-Day Done Right Promise. If something isn’t right within a year, we make it right. Our techs carry live arrival times you can track on your phone. And if you ever decide you want to look at something besides Rheem, we’re certified on Carrier, Trane, and Lennox too, so you’re getting brand-level advice, not a sales pitch for whatever’s on the truck.
FAQs
Yes. Rheem offers a 10-year parts warranty on most current AC installation models when you register the unit within 60 days of install. If you skip registration, the parts warranty drops to 5 years. We register every Rheem we install, and we handle the warranty paperwork for you. Call (850) 608-1463 if you need help figuring out what your specific Rheem still covers.
Most Rheem AC installations in Tampa are completed within five to seven business days of quote approval. If your home has no working AC in the middle of a Florida summer, call (850) 608-1463 and we’ll tell you the fastest honest timeline for your specific setup.
The general rule is if the repair costs more than 30 percent of a new system, replacement makes more sense, especially if your Rheem is over ten years old. We’ll give you both prices in writing and let you decide. No pressure. Call (850) 608-1463 for a straight answer on your specific unit.
We install both Rheem straight-cool condensing units and Rheem heat pumps, which handle heating and cooling in one system. Tampa winters are mild, so a heat pump Rheem AC installation can often eliminate the need for a separate furnace. Your call, but we’ll show you the math.
Ready to Get Your Rheem AC Installed in Tampa?
Call Halden Heating and Air Tampa at (850) 608-1463 for a free estimate. We’ll send a tech with a live arrival time, give you the price in writing before anything happens, and you’ll know exactly what you’re paying before a single tool comes off the truck. Rheem AC installation in Tampa is a big decision. We make it a simple one.
Written by Andre Fuller, Owner, Halden Heating and Air Tampa at Halden Heating and Air Tampa, serving Tampa and nearby areas.